The plan is to do it cheap, well as cheap as possible. We have maybe £1000 to do the outside so we will see. I have £500 to do the inside.
The big work has to be the outside.
The main problems on the outside have been covered on this topic
https://club8090.co.uk/forum/viewtopic.php?f=38&t=155725" onclick="window.open(this.href);return false;
New panels will be needed, this is the list I have made to buy from Alan Schofield
Front Door Step Repair Left 80->.
Front Door Step Repair Right 80->.
Correct Sill & Side Panel, Spot Welded. 80-92. 2
Lower Rear Corner Right 80->.
Lower Rear Corner Left 80->. 2
Lower Front Panel Repair 80->. 251-805-036
Total of £173
Now can I find a decent welder who can get this within my budget.
Inside... over the weekend I have stripped the whole thing. Previous owner has put fibreglass on (that stuff is itchy)
Do I need to take it off completely??
Would the next step now be to do the welding outside??
Once the outside is done, to insulate I was planning on putting this first
http://www.wickes.co.uk/Rockwool-Therma ... m/p/148843" onclick="window.open(this.href);return false;
followed by a layer of this
http://www.wickes.co.uk/Wickes-Thermal- ... m/p/210022" onclick="window.open(this.href);return false;
Does this sound OK??
Inside by the fridge area I have seen some horror pics, but mine wasnt too bad. Wire brushed to metal.. One small hole. I have put some Hydrate 80 http://www.bilthamber.com/corrosion-pro ... hydrate-80" onclick="window.open(this.href);return false; on it then covered with electrox http://www.bilthamber.com/corrosion-pro ... s/electrox" onclick="window.open(this.href);return false;.
Should I patch it or would that be enough??
Here is the pic (obviously not the hole in the middle
)
I want to also underseal the van, but will get outside done first.. but before that, can I use electrox on the trailling arms??
Any advice greatly appreciated, am I doing OK or do I need to do change something drastic.
PS Sorry about all the questions
ooo one more question, painting inside?? Cant roller that so can I just paint rustoleum on with a brush once i have keyed the surface?? Take it thats a window seals out job