Skim board table

Post by **moggymorgan** » 06 Sep 2016, 18:34

Hi guys.
Thinking of replacing the table with a skim board.i know it's been done many times but how do you attach it to the leg bracket ? I presume a thicker plate would be needed for the screws.thanks for any advice.

Post by **fazzer** » 06 Sep 2016, 20:00

I cut a piece of wood(about one and a half inch thick) the same shape as the bracket and glued it to skim board also I flattened the board with steam and weights to get it flat.

Post by **moggymorgan** » 07 Sep 2016, 08:10

fazzer wrote:I cut a piece of wood(about one and a half inch thick) the same shape as the bracket and glued it to skim board also I flattened the board with steam and weights to get it flat.

Thanks fazzer, I will give it a go,

Post by **Domino** » 07 Sep 2016, 13:51

I used apoxy and it's worked a treat

, chap on eBay will copy a pic of your van onto one for £50 , He does a great job

Post by **Winchweight** » 07 Sep 2016, 15:29

I epoxied a piece of 18mm ply to the bottom, cut to the shape of the Fiamma table leg bracket. Been there 3 years and still going well.

Post by **moggymorgan** » 07 Sep 2016, 17:56

Cheers guys,going to experiment with epoxy and a plate.

Club 80-90 Forums

Skim board table

Skim board table

Re: Skim board table

Re: Skim board table

Re: Skim board table

Re: Skim board table

Re: Skim board table