Elongating bell housing to fit 1y

[Smcknighty]

Intending to use the 1Y windage tray with the elongated holes plated over to try to prevent surging of oil up into bores on hard braking. (Peteabbott experienced something that may have been this). Bell housing will need sump bolt holes elongating by 2 or 3mm.

I had to extend the two gearbox holes where the sump bolts on by a couple of mm due to the thicker gasket, but easy enough

Sent from my iPhone using Tapatalk

[Smcknighty]

So I'm going down this route - it's quite a lot of metal to remove - before I get stuck in did you just file it or did you get it machined?


Sent from my iPhone using Tapatalk

[Oldiebut goodie]

Just get yourself a http://www.ebay.co.uk/itm/Hot-M2AL-HSS- ... SwRLZT0LNx - can't remember what size I used though. That is a 10mm one. It's not that difficult to do, just have to ensure that you are elongating it in the correct direction! Not a lot of metal to be removed.

[Smcknighty]

Nice! That doesn't look to painful. I'm going to use the pooh plate to mark it up. I wasn't looking forward to filing all that


Sent from my iPhone using Tapatalk