Alternative instruments and switchgear

[silverbullet]

I have a feeling that a but of dash panel surgery may be necessary for the SD1 pod, basically a cut n fillet to level off the slope of the dash top.
No point having instruments that I can't read!

[silverbullet]

PS I also have an idea for altering the angle of the steering wheel, but its not a DIY job (I have made steering shafts before, for AC Cars before they finally went bust!)

[Smiffo]

Changing the dash means that the VW buzzer/DOPWS will go, so just one switch for the low pressure warning lamp (I will use the highest I can find, 1 bar at least) the other tapping on the engine will have the pressure sender for the gauge.

I see. That makes sense. Cheers SB

[lloydy]

Ian, i have a dashboard in my garage taking up space if you want it muck around with?

[silverbullet]

RHD?

[lloydy]

Ah no....... But each end must be the same profile for mucking around me with?

[silverbullet]

Ta but no use to me. Can't offer it up to check master brake cylinder clearance etc

[lloydy]

ok

[silverbullet]

Improved the line of sight to the RR dash pod with the tiniest of adjustments. It could go a smidge lower, its doable and there is still good knuckle clearance.
http://i1103.photobucket.com/albums/g47 ... oonks0.jpg" onclick="window.open(this.href);return false;
I sat down last night and tried to count the turns/mile but whilst the speedo worked, the odo didnae...
Took it all apart to find a dead spider inside and a sticker on the mechanism that says 1000 revs.
Fished out the cadaver and the silk strands and now it counts the miles
http://i1103.photobucket.com/albums/g47 ... kltfqh.jpg" onclick="window.open(this.href);return false;
So now I will need a 16:10 reduction box in the speedo cable if this is going into the syncro... could be a mini project in itself.
Like I need another one.

[silverbullet]

Still no idea on switchgear though

[MGP]

RHD dash here if you want it. Poverty spec with loads of holes drilled into it.

[busbuddy]

i forgot to post this





it was posted by a bulgarian owner on our forum last year, he had fitted the engine from the car as well so it all worked

[silverbullet]

Whats that dash from then?

[busbuddy]

citroen synergie

[silverbullet]

Ah yes. C8/ Pug 806/Fiat Ulysse. Not many vehicles that wide.