T4 wheel Fitment to T25

[bilbothebrave]

Hi looking for some advice please
Can I fit a set of alloy wheels that have fitment for a T4 to a T25

Heres the spec on the wheels

Material Alloy
Rim Diameter 17 inch
Rim Width 8J
Offset 35
Stud Diameter 112
Number of Studs 5

Would adapters etc be required

I would appreciate any advice,
but please, Im not a techie, so explanations in plain English please ............. as I wouldnt want to ask a further 50 questions on what the answers mean
Many thanks

[chris7ian]

You'll most likely need a 5mm spacer at the front to clear the suspension on full lock, and you may want a 10mm spacer (and therefore longer studs) at the back to even things out visually.
Anything significantly more than this and you start affecting geometry...

[Synkraut]

Center bore for T4 was 57,1mm, the T25 requires 66,5mm

[R0B]

That's a lot of metal to remove.

[kevtherev]

More than I'd feel comfortable with

[silverbullet]

I have bored out a few wheels. If any come in that look like they will be sketchy after machining I refuse to do them.
Pics of the hub side of the wheel centre with a tape measure in shot might help here.