Is this right (Bumper)

[a1winchester]

Until I had my bumpers off for a re-spray, I never noticed this before.
(There's lots of things I never spotted until this exercise!)
This in a 1990 Autosleeper with the larger wrap around bumpers.
On some pics I have seen, the top of the bumper looks to be parallel with the bodywork swage. On my van, it's not. - See pic.



The question is - Is this right? The end of the bumper lines up ok with the wheel arch, but it looks like it could be wrong. If I try to lift the bumper return, it kicks out the connection with the back bumper.

I suppose the van could have been rear ended or been reversed into something. But maybe this is how it should be?

Any thoughts, anyone?

[what2do]

Is it a single piece fibreglass one or an OEM (3 separate parts)?

[silverbullet]

The side brackets underneath are adjustable

[a1winchester]

Is it a single piece fibreglass one or an OEM (3 separate parts)?

3 parts

[what2do]

That rules out my possibility of poor repros then. Better trust Ian's suggestion instead

[a1winchester]

Looks like it might have something to do with the tow bar kicking the main bumper out of true, which then leads the end returns to run at an angle. I never worried (or even noticed) before, but now the van has been tidied up, I might need to do something about it.
Not #1 priority at the moment though.