Interior panels

[RLG]

I want to panel out the inside of my bus but don't really want to spend £90 on a plywood kit can you get the measurements from anywhere or can you get any blue prints ..
Any help would be greatly appreciated

[Jonnyb416]

You could possibly make them out of cardboard then use that as a template.

[RLG]

Ye I considered that but might be tricky to get the clips in the right place

[NicBeeee]

I made ours from card templates, not thick card but the craft type, you can also use thick wall lining paper, push a pen through were the holes are, I also used hardboard as opposed to thin ply to make the panels, ply always seems to brittle and the hardboard gives a little which doesnt crack or pop out of its holes, also give it a coat in watered PVA to give it damp protection particularly on the door panels. Others have different ways but this is what I like to use, hardboard is also cheaper wickes smooth one side and meshed on the other £6.90 for a big sheet and easier to cut, you can even cut it with a stanley.

[RLG]

Ok sounds like a good plan thankyou