Engine trouble

Big lumps of metals and spanners. Including servicing and fluids.

Moderators: User administrators, Moderators

Post Reply
User avatar
Margo88
Registered user
Posts: 23
Joined: 18 Jul 2015, 19:12
80-90 Mem No: 14797
Location: Tunbridge Wells, Kent

Engine trouble

Post by Margo88 »

Hi, I am new to this forum and also new to t25 ownership. I have recently bought a 1988 1.9 dg water cooled petrol t25.
The van starts fine and drives lovely from cold. As soon as it warms up it starts playing up. Symptoms are engine stalls, lose of power under load. You can depress the throttle and ... Nothing. The van restarts ok when it stalls but runs very lumpy. It is fitted with a weber carb. My initial thoughts were a blockage or partial blockage in the Jets. I have cleaned the carb out, can't see or hear any air leaks but the symptoms remain. I have noticed slight burn marks on the inside of the distributor cap and on the rotor arm. Could this cause these symptoms?

Hope to get some replies from some knowledgeably people! Other than this engine trouble, I have well and truly caught the t25 bug!!

User avatar
itchyfeet
Registered user
Posts: 12425
Joined: 23 Jul 2007, 17:24
80-90 Mem No: 12733
Location: South Hampshire

Re: Engine trouble

Post by itchyfeet »

Hot engine trouble can be coil breaking down.

Dizzy caps are not expensive, just replace it if in doubt.
1988 DG WBX LPG Tin Top
itchylinks

User avatar
Margo88
Registered user
Posts: 23
Joined: 18 Jul 2015, 19:12
80-90 Mem No: 14797
Location: Tunbridge Wells, Kent

Re: Engine trouble

Post by Margo88 »

Thanks. Yeah. Someone must've retro fitted the weber at some point. I've got new dizzy cap and rotor arm on order. Will fit Monday. Doesn't smell of fuel. I believe it is automatic choke. I think the choke is the plate on the top of the carb (visible when the air filter is off). This is partially closed when cold and opens when hot. Do you know the correct procedure for checking the coil?

User avatar
itchyfeet
Registered user
Posts: 12425
Joined: 23 Jul 2007, 17:24
80-90 Mem No: 12733
Location: South Hampshire

Re: Engine trouble

Post by itchyfeet »

You can test the coil resistance but if it's hot then it's probably faulty.
Primary 0.5 to 0.8 ohms
Green sticker 2.4 to 3.5 k ohms secondary
Grey coil 6.9 to 8.5k ohms secondary

Image
1988 DG WBX LPG Tin Top
itchylinks

User avatar
Margo88
Registered user
Posts: 23
Joined: 18 Jul 2015, 19:12
80-90 Mem No: 14797
Location: Tunbridge Wells, Kent

Re: Engine trouble

Post by Margo88 »

Thanks very much. I'll test it tomorrow.

User avatar
itchyfeet
Registered user
Posts: 12425
Joined: 23 Jul 2007, 17:24
80-90 Mem No: 12733
Location: South Hampshire

Re: Engine trouble

Post by itchyfeet »

Measure insulation also ( shown in diagram) it should be very high or open loop on meter.
Also worth cleaning up earths on engine head and under coil.

My guess is more likely ignition than fuel
1988 DG WBX LPG Tin Top
itchylinks

User avatar
Margo88
Registered user
Posts: 23
Joined: 18 Jul 2015, 19:12
80-90 Mem No: 14797
Location: Tunbridge Wells, Kent

Re: Engine trouble

Post by Margo88 »

Morning. Just checked the coil. Primary and secondary resistance ok. Insulation 1 - 1.5 mega ohm. This is low. Do you suggest replacing coil?

User avatar
itchyfeet
Registered user
Posts: 12425
Joined: 23 Jul 2007, 17:24
80-90 Mem No: 12733
Location: South Hampshire

Re: Engine trouble

Post by itchyfeet »

Thing is they break down hot (cold can measure OK) so give it a drive until it cuts out, open the hatch and see if the coil is hot to touch.
1988 DG WBX LPG Tin Top
itchylinks

User avatar
Margo88
Registered user
Posts: 23
Joined: 18 Jul 2015, 19:12
80-90 Mem No: 14797
Location: Tunbridge Wells, Kent

Re: Engine trouble

Post by Margo88 »

Hi. Coil was ok. I took the carb off and cleaned it ... Properly this time! Just gone for a test drive. Engine up to temp ... No stalling or hesitation. Smooth power through the Rev range so hopefully she is cured! Thanks for your advice.

Post Reply