Our '99 ADY Shazzer has one...
AVG (AFN) into Panel Van
Moderators: User administrators, Moderators
-
silverbullet
- Trader
- Posts: 17634
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Re: AVG (AFN) into Panel Van
I want to see your face when you spot a pulley with the blue oval stamped on it
Our '99 ADY Shazzer has one...
Our '99 ADY Shazzer has one...
1985 Oettinger 3.2 wbx-6 Caravelle RHD syncro twin slider. SA Microbus bumpers, duplex winch system, ARC 7X15 alloys,
"Schrödinger's syncro"
Syncronaut #156
"Schrödinger's syncro"
Syncronaut #156
-
max and caddy
- Registered user
- Posts: 1932
- Joined: 21 Feb 2012, 21:47
- 80-90 Mem No: 0
- Location: lancaster uk
Re: AVG (AFN) into Panel Van
Hmmm yes there are some contaminated parts in use...but doubt you will find those on the Diesel engines.
-
jes*b
- Registered user
- Posts: 879
- Joined: 25 May 2008, 09:41
- 80-90 Mem No: 10335
- Location: folkestone, kent
Re: AVG (AFN) into Panel Van
despite my best intensions for 2015 to divest myself of a vw or 2 another AFN shazza has landed. runs sweet just got one too many body bits falling off to make it a viable family motor so donated to the cause. shall park it up and ignore, until i need something i guess.
-
jes*b
- Registered user
- Posts: 879
- Joined: 25 May 2008, 09:41
- 80-90 Mem No: 10335
- Location: folkestone, kent
Re: AVG (AFN) into Panel Van
Going to be keeping the VNT shazza turbo as its got 0 miles on it from Midland Turbo. Want to maximise it's effectiveness so what are my options re. Manifold / exhaust / re indexing if needed . Input required please .
Also spoke with Andy re. Loom requirements as as Panel Van will be factory inside ie empty , the best place for ECU will be in engine bay . As its come from a shazza where it lives indoors it will need enclosing and or waterproofing . Anyone found something OE looking and suitable for the job ?
Also spoke with Andy re. Loom requirements as as Panel Van will be factory inside ie empty , the best place for ECU will be in engine bay . As its come from a shazza where it lives indoors it will need enclosing and or waterproofing . Anyone found something OE looking and suitable for the job ?