chuckle-bus-tom wrote:
I would be very interested in doing this on my factory eber. I have the factory timer module on the dash, but the display screen is dead, so I have no way of testing it. Was the remote easy to fit?
Yes it was very easy to fit. It simply requires an earth and a live feed. Then there is a relay on the (small) unit that has the usual "normally open" and "normally closed" contacts. I took a suitable 12 volt feed to one of the "normally open" terminals and then a (red) wire from the other "normally open" terminals and spliced that into the main 12 Volt Propex feed wire, the one that fires it up. Hey presto, I can now turn on the Propex from inside my house. Admittedly, the way I did it, the stat is not in the circuit when I fire it up using the relay, but that is no problem as I will only have it on for 1/2 an hour or so whilst I get ready for work. For more "normal" use, when camping etc, the stat works the same as it always did. I installed it fairly high up in one of the cupboards so the little receiving aerial (bit of wire) is not masked by too much metal bodywork, I used double sided tape to mount the (fag packet sized) box.
Worth noting that I use a
SafeFill gas bottle that can be legally filled at any normal LPG garage. This reduces the cost of running the Propex (and cooker and fridge) hugely. So much so that I can use the heater any time without worrying about the cost of the gas. Also I can see how much gas I have left and so never have to guess and run the risk of running out on a cold night. Win win
