gearbox leak

Post by **HarryMann** » 27 Jun 2006, 22:13

They're £25 each at GSF with a bit of discount..

If you don't change the outers as they feel OK and don't , then at least get the grease back around the joint by squeezing the boot.

Wki on CVJ internals
http://www.club80-90.co.uk/wiki/index.p ... nts_repair

Wiiki on Brakes...
http://www.club80-90.co.uk/wiki/index.p ... _Backplate

http://www.club80-90.co.uk/wiki/index.p ... _servicing

Post by **trikey** » 01 Jul 2006, 12:51

Cheers for all the advice, i have now fitted the driveshaft oil seal, four CV gaiters and new pads and shoes and theres noway that i could of done it without the help of this forum, just need to keep an eye out now for that 1.9 D engine and i`ll be sorted,
cheers all
Sean

Post by **cooky73** » 31 Jul 2006, 19:38

can this job be done without removing the other end of the driveshaft from the hub etc. ???

Post by **HarryMann** » 31 Jul 2006, 19:46

Yes

Post by **cooky73** » 01 Aug 2006, 08:29

nice one - can't see the driveshaft oil seals in gsf or euro though - are they a dealer only part?

jk don't seem to have them in the catalogue either?

Post by **HarryMann** » 01 Aug 2006, 09:35

VW

091 301 189 (Seal)

002 301 185A (Ring) - Not sure if you'd need this part, but its listed as part of a repair kit..

Anyone?

Post by **cooky73** » 01 Aug 2006, 09:49

Nice one - will go to the $tealers now

Post by **cooky73** » 01 Aug 2006, 13:34

they are ordering the bits from Germany

20 quid for both - seems ok!

Post by **HarryMann** » 01 Aug 2006, 16:23

Good, they might realise sooner or later that thse are bist that should be in stock at MK