Jessabelle, The saga begins
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Jessabelle, The saga begins
Have been meaning to start a post about the 'freshening' of my bus for ages but it's been ongoing for a while, being a tech I'm too busy fixing other peoples cars than finding time for Jessabelle! The viscous cycle!
The engine is out as it had a ring problem on cyl 1. Her body isn't that bad compared to some posts on here but am under no illusion it may get worse the deeper I get. Here's a few photos to get it going
Any advise is welcome, and will update when I can or have done something new
The engine is out as it had a ring problem on cyl 1. Her body isn't that bad compared to some posts on here but am under no illusion it may get worse the deeper I get. Here's a few photos to get it going
Any advise is welcome, and will update when I can or have done something new
- mrhutch
- Registered user
- Posts: 1111
- Joined: 09 Jun 2006, 09:27
- 80-90 Mem No: 2698
- Location: Herefordshire & all over
Re: Jessabelle, The saga begins
nice SA bumpers on there... is it an early SA van?
1981 Vanagon Westy Burning oil as fuel...
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
Shows how little I know, uk van as far as I'm aware will check the vin and work it out
-
- Trader
- Posts: 8047
- Joined: 12 Oct 2005, 20:55
- 80-90 Mem No: 1948
- Location: lincolnshire
Re: Jessabelle, The saga begins
Just don t leave any rotten rusty bits behind,and if you decide to do the panel behind the slider runner/ bottom of window ,I have these ,good luck with it
mm
mm
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
MM
Are those slider panels made to match the full height arches? And how much?
Are those slider panels made to match the full height arches? And how much?
-
- Trader
- Posts: 8047
- Joined: 12 Oct 2005, 20:55
- 80-90 Mem No: 1948
- Location: lincolnshire
Re: Jessabelle, The saga begins
Yep ,will pm you
-
- Trader
- Posts: 8047
- Joined: 12 Oct 2005, 20:55
- 80-90 Mem No: 1948
- Location: lincolnshire
Re: Jessabelle, The saga begins
here page 9>>>
http://forum.club8090.co.uk/viewtopic.php?f=38&t=114490" onclick="window.open(this.href);return false;
it goes higher up the side and longer but i cut down to fit as needed
mike
http://forum.club8090.co.uk/viewtopic.php?f=38&t=114490" onclick="window.open(this.href);return false;
it goes higher up the side and longer but i cut down to fit as needed
mike
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
Anybody know why the pics have disappeared?
-
- Registered user
- Posts: 144
- Joined: 13 Mar 2007, 23:21
- 80-90 Mem No: 12366
- Location: sunny west wales
- Contact:
Re: Jessabelle, The saga begins
MMs panel is good
I fitted one a couple of weeks ago!
Best of luck with it all!
I fitted one a couple of weeks ago!
Best of luck with it all!
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
Freshly powder coated and new powerflex bushes, love them or hate them they do look good!!
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
Brakes painted and ready for new ball joints etc
-
- Registered user
- Posts: 22
- Joined: 20 Jan 2013, 14:13
- 80-90 Mem No: 11965
- Location: Southampton
Re: Jessabelle, The saga begins
Busy ready for MM's slider panel