http://www.thesamba.com/vw/forum/viewto ... sc&start=0" onclick="window.open(this.href);return false;
neil
Arctic syncro
Moderators: User administrators, Moderators
- axeman
- Registered user
- Posts: 1254
- Joined: 07 Feb 2009, 19:50
- 80-90 Mem No: 6410
- Location: Smeeth kent country side
Arctic syncro
Back in the game with an uncut 2wd panel van
- syncro up
- Registered user
- Posts: 212
- Joined: 09 Aug 2007, 18:57
- 80-90 Mem No: 3981
- Location: Scotland
Re: Arctic syncro
Very interesting. Been on the wish list for a while.
This the time of year when you think about the snow rally again?
This the time of year when you think about the snow rally again?
Life is like a roll of toilet paper
The closer it gets to the end, the faster it goes...
Todays might Oak is just yesterdays nut which held its ground!
'87 Rhd 2.1 Syncro Moonraker
'91 Rhd AAZ Syncro Sika
'03 Merlin Syncro Expedition Trailer
The closer it gets to the end, the faster it goes...
Todays might Oak is just yesterdays nut which held its ground!
'87 Rhd 2.1 Syncro Moonraker
'91 Rhd AAZ Syncro Sika
'03 Merlin Syncro Expedition Trailer
- ninja.turtle007
- Registered user
- Posts: 2234
- Joined: 04 Jun 2009, 16:07
- 80-90 Mem No: 7278
- Location: Surrey
-
muileach
- Registered user
- Posts: 19
- Joined: 17 May 2007, 13:34
- 80-90 Mem No: 0
- Location: ISLE OF MULL
Re: Arctic syncro
this land rover from Lix Toll garage in Perthshire was at our local agricultural show giving a demonstration which was very impressive, the tracks are bolted straight onto the hubs using the existing wheel studs and nuts and can be fitted in 20 minutes. It is road legal and can be driven with an ordinary driving licence as it sill has ordinary steering, the max speed is about 40mph but you have to be brave to go above 30 as it tends to shake you to bits. The garage use it as a recovery / rescue vehicle in the snow in the winter and it will go almost anywhere, the demonstrator recons they could be fitted to a syncro providing there is enough clearance it would be a case of getting the drive sprocket machined to fit a syncro hub.
Have put them on my wish list but lottery would have to come up first
Muileach
Have put them on my wish list but lottery would have to come up first
Muileach