Evening all. When I bought the van, I knew there was a monster welding job to be done on the floirpan/sill where the sliding door opens. As it turns out, I'm in luck as the only rot was to the horizontal channel where the rubber seal fits. A few spot welds to grind off , hey presto, once the channel was removed the rest was solid. This just means that I require the U-shaped channel, does anyone know if these are available to purchase?
Cheers.
channel needed.
Moderators: User administrators, Moderators
-
what2do
- Registered user
- Posts: 2853
- Joined: 05 Oct 2012, 08:55
- 80-90 Mem No: 11974
- Location: Salisbury
channel needed.
Why would the glass be anything other than half full?
'89 panel van, 1.9 DG.
'89 panel van, 1.9 DG.
-
Plasticman
- Trader
- Posts: 8078
- Joined: 12 Oct 2005, 20:55
- 80-90 Mem No: 1948
- Location: lincolnshire
Re: channel needed.
schofields £10
mm
mm
-
what2do
- Registered user
- Posts: 2853
- Joined: 05 Oct 2012, 08:55
- 80-90 Mem No: 11974
- Location: Salisbury
Re: channel needed.
Result! Thanks a bunch, this is one of those rare jobs - far easier and cheaper than initially thought.
Cheers.
Cheers.
Why would the glass be anything other than half full?
'89 panel van, 1.9 DG.
'89 panel van, 1.9 DG.