Rear hub assembly

[arch]

Hi

I fitted a 4x new set's of bearings about 9-10 mth's ago. They are all good bar the rear offside. On taking it apart the bearing fell out in small bits."Great!!!"
On that i have pressed a new set of bearings in and it feels that it's running untrue and very notchy.
I'm after a complete hub assembly I think unless anyone has any idea's

Any help would be appreciated

Cheers Arch

[nobbyfox]

Not enough grease? I assume that you used the grease supplied with the bearings.
Or you could of had a bearing made in a Friday afternoon!!
Good luck

[arch]

I have got a new set of bearings in the hub assembly now and have bolted it back together with out attaching to the van and it feels very shonkey. Grrr HELP!!!

[nobbyfox]

Mine were press fit and put in with a hydraulic press using the old race and a socket (plus steel sheet and wooden block) to push it in.
Are you sure they are in square? But that would not explain the 'shonkeyness" Does it feel gritty?

[Oldiebut goodie]

Not another set of GSF chocolate bearings?

[Plasticman]

have a look on the outside edge of the race and see what maker it is and the ser number
mm

[Ian Hulley]

http://www.brickwerks.co.uk/shop?page=s ... gory_id=80

Nuff said ^^

[arch]

Not another set of GSF chocolate bearings?

Tried them once and that went all wrong. They only lasted 10 mth's

[arch]

Set of fag's. The race is pressed in nice and tight and as square as can make out and Loaded with grease. I've bolted it altogether with out attaching to the van and it feels like it's untrue and as if it's pressing on the bearings to tight in a couple of places and then loosens up. In other words Crap! New bearing carrier is needed as I believe the old bearings naffed the carrier. The bearings came out in bits.

Wot you all reckon?

[Oldiebut goodie]

I am only seeing reference to one bearing - you did replace both the inner and outer? Did you degrease everything and ensure that no bits were stuck in some greasy recess before reassembling? (just double checking )

[arch]

Hi

All pulled apart, Cleaned out, De-greased and yes inner and outer bearings done, Packed with grease, All bolted together and still runs shonkey. It's not all attached to the van as yet as i wanted to test it all out and make sure it ran nice and smooth before hooking upto the driveshaft. It's a right royal pain in the butt.
I have found a carrier but i'm still unsure.
WOT U REKON??

[arch]

Hi All

The Spud bus is fixed.

Fitted another bearing carrier, inner & outer bearings.

M.O.T Done.