ebber problem?

[Big Boris]

Hi all ,
ive been using my van to live in on site for most of the summer and using my ebber sucesfully on a regular basis ,but i tried to fire it up the other day and it started clicking but no fan noise ,so tried it again and nothing works now there is no green led light or fan noise or anything ,ive looked at the fuse behind drivers seat and that seams ok ,ive had the engine running and elec hookup so no worries there ,is there another fuse somewhere that might have gone ? ,the van is an 89 westy california with a 1.6td engine so it runs of the diesel ,there is no led display its just a dial with a switch and a green led ,any help would be greatly appreciated ,
borris

[Oldiebut goodie]

Eberspacher model?

[Big Boris]

hi ,im not sure on the model ,its mounted externally if that helps ,is there a model number somewhere ?

[Oldiebut goodie]

Assuming that it is a factory fitted it most probably is a D2L. Some versions have a fuse in the ECU - the value should be marked on the ECU case.

[Big Boris]

ive had a search and it looks like its the D2L ,do you know this one ?
ta
borris

[Big Boris]

thanks oldie but goodie il have a look and report back

[Big Boris]

just got around to getting the ecu out ,and yes there is a fuse its a T1 25/250v which is engraved in the end cap of the glass fuse ,the wire in the fuse doesnt seem to have broken ,i assume that if its the fuse then i will clearly see the wire broken
ta borris

[1664]

assume that if its the fuse then i will clearly see the wire broken

Not necessarily, it can rupture next to the end out of sight. A multimeter is the only sure way to check a fuse is ok

[Oldiebut goodie]

Fuse should be T 1.25 - I hope you have just misread it!
Time to check for leaves etc. causing the fan to jam and integrity of all wiring to and from the ECU. Have you altered any earthing points? After that it may well be time to strip it all down. When was it last serviced?

[Big Boris]

ok thanks ,ive got a multimeter what do i need to do with it please im not to sure

[Big Boris]

il have to wait for the snow to go before i am able to check for leaves ,and i have never had it serviced since owning the van thats the last 5 years

[1664]

ok thanks ,ive got a multimeter what do i need to do with it please im not to sure

Can you pop a picture of it on?

[Big Boris]

of the fuse or multimeter ?

[1664]

Multimeter. I want to be able to tell you where the continuity / ohm range is

[Big Boris]

hi ,
bit of an update ,thanks 1664 but i decided to buy some new fuses that way id be sure that it isnt the fuse ,so ive replaced the fuse and fitted the ecu back together and still nothing dead as a dodo so thats the fuse behind drivers seat ok and the fuse in the ecu replaced and still no power
any more ideas guys ?
ta borris