Water Cooled Inlet Manifold

Post by **reikiman87** » 05 Jan 2013, 11:02

1987 T25 watercooled 1.9 DG . Hi I`ve got a small hole inside the inlet manifold that is leaking water . Bought some alloy brazing rods but I`m struggling to heat the manifold metal sufficiently to melt the alloy rods. Tried using butane/propane blow torch but not hot enough. Any ideas on this or any other brainwaves on how to block the hole or failing that does anyone know where there`s an inlet manifold for sale.Thanks

Post by **Hacksawbob** » 05 Jan 2013, 14:19

How about liquid metal?
http://www.loctiteproducts.com/p/mech_s ... -Putty.htm

Post by **reikiman87** » 05 Jan 2013, 15:00

Hi thanks, yes we`ve tried this product firstly but no matter what we do the putty doesn`t seem to stick to the metal sufficiently.

Post by **bigherb** » 06 Jan 2013, 14:34

Have you tried Lumiweld sticks it flows at lower temperatures.

http://www.ebay.co.uk/itm/Lumiweld-10-R ... 0531564152

Post by **Oldiebut goodie** » 06 Jan 2013, 14:41

The problem is the lack of pre-heating I suspect, preheating in an oven turned up full would help.

Post by **kevtherev** » 06 Jan 2013, 14:49

I have a good DG inlet manifold you can have if you get fed up.

£40 plus post.. or pick it up free
put your location in your profile then someone could be passing etc

Post by **Oldiebut goodie** » 06 Jan 2013, 14:59

Can it not be cured by the laying on of hands?

Club 80-90 Forums

Water Cooled Inlet Manifold

Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold

Re: Water Cooled Inlet Manifold