Westfalia Perspex Side Window Fitting

[timthemod]

I bought the following window to replace my non-opening window in the camper. Mainly because is opened and also because it has the correct dimensions as a replacement. All the sliding windows I see are smaller and therefore won't fit the hole that has been cut in my ex panel transporter.
http://www.ebay.co.uk/itm/130812890615? ... 1497.l2649" onclick="window.open(this.href);return false;

Problem is it has no fitting seal and I'm not sure how it's fits?

Any adviced much appreciated.

[Plasticman]

hmm, not sure you can fit it in a panal conv'n
the top hinged window fits into an upper part that fits to the aperature of a factory glaszed window hole, and there are a few other bits you need,
will have a look for a few pickies of one ive done unless someone else can post the picks up
mm

[Plasticman]

Hi see here
https://club8090.co.uk/forum/viewtopic.p ... &start=165" onclick="window.open(this.href);return false;
next is an ally strip that receives the hinge part fastened to the window and then another finnisher at the end
also 2 brackets on the body sides to receive the widow stays/locks and one at the bottom , then a seal roun d the window aperature,
i think i have a spare window in the shed, if i get a chance will diog it out and take a picky as i think its complete
mm

[timthemod]

Thanks guys, looks like I
bought something I can't use