Leak

Post by **Dave307** » 23 Oct 2012, 19:22

Sorry for hijacking the thread. i have looked on various sites and there are different rubbers available. What sort should i buy and wee is the best place to get one from.

Website · Post by **CovKid** » 23 Oct 2012, 20:47

Do NOT buy the Just Kampers ones. You want as close to original as possible or it will leak and/or look terrible. Yes it might cost £10 or even £25 more for a better seal, but for a job that may only be done once in the vehicles life, there are no savings to be had in my view. VW Emporium have the right ones - with or without chrome locking trim. In fact, if you read through my WIKI article on repairing the lip, it does say all this anyway.

Post by **Dave307** » 23 Oct 2012, 21:26

Magic thanks.
i have been sent a link to a good one.
As always cheers for the advice.

Post by **nathanwedge** » 03 Nov 2012, 15:01

Windscreen seal finally done today and the good News is only slight surface rust ! Wiper spindle nuts were a bit slack too so ll back together and just wait for the rain (not that long !)

Post by **meggles** » 03 Nov 2012, 18:25

nathanwedge wrote:Windscreen seal finally done today and the good News is only slight surface rust ! Wiper spindle nuts were a bit slack too so ll back together and just wait for the rain (not that long !)

Glad it wasn't too bad. Did they treat the surface rust. If you use a silicone type sealer around spindles make sure it's an automotive one. The ordinary type can cause corrosion it seems.

Post by **nathanwedge** » 06 Nov 2012, 21:16

Seal changed at the weekend, no rot just a bit of very light surface rust all treated and new screen back in. It rained today and no leaks (fingers crossed) I've stuck a dehumidifier in for a couple of days to dry it all out. Cheers for the advice all.

Post by **meggles** » 07 Nov 2012, 10:10

nathanwedge wrote:Seal changed at the weekend, no rot just a bit of very light surface rust all treated and new screen back in. It rained today and no leaks (fingers crossed) I've stuck a dehumidifier in for a couple of days to dry it all out. Cheers for the advice all.

Pleased for you mate.

I'm sure you understood our concerns

Website · Post by **CovKid** » 07 Nov 2012, 18:05

Once the seal is all in and its settled down, run round with the roofing mastic as I suggest in the WIKI. Makes the seal watertight then.

Post by **Dave307** » 09 Nov 2012, 15:17

If pics come up(fingers crossed) just had new seal fired in mine today. No rust. Thank God.
Now its fingers crossed that it was the seal that was the problem. I'm hoping so. I had exactly the same issue. Oh and thanks to MM for the seal link and advice.

Club 80-90 Forums

Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak

Re: Leak