how do i fix this

Post by **hippy chick** » 08 Sep 2012, 15:10

my 1983 1.9 waltercooled t25 has been starting then not starting i have trace the fault to this if i get it running the touch the wires it cuts out. while trying to pull this plug i pulled a wire out . do i have to buy a new part not sure what you call this part. or can i fix this one. many thanks jen

Post by **The Bishop** » 08 Sep 2012, 15:14

Whoops!

I dare say you can buy new plugs or you could strip a little wire back and solder it back onto the bit of wire that is still in the socket to get you running again.

Post by **nevill3** » 08 Sep 2012, 15:23

A new connector looks like it is needed, they are cheap, a quick look on VAGCOM says they are less than 2 euros I think it is number ten in the image The Part number is 211905327 probably available from VW locally.

Post by **hippy chick** » 08 Sep 2012, 15:36

thank you both or your replys

i will order a new conector then. thanks again jen

Post by **The Bishop** » 08 Sep 2012, 15:46

I had the same problem with the Buzzer of Doom connector in Germany, The garage "couldn't" fix it and yet I could "bodge" it up with a bit of solder,

Now I know where to buy a bnew connector and do the job properly.

Post by **hippy chick** » 08 Sep 2012, 17:14

think i will try to solder it , till new one gets here.

think i will leave it till tomoz i just shut sliding door and the new rubber i had fitted has let the window slip down and the rubber is hanging

Post by **Wychall** » 08 Sep 2012, 18:58

If you look carefully into the plastic bit, you should be able to see a little tang on the side of the brass connector. Ease the tang back with a jewellers screwdriver or similar and you should be able to withdraw the connector from the plastic. Makes it much easier to solder and may make replacement unnecessary.

Post by **California Dreamin** » 08 Sep 2012, 20:07

With the tell tail signs of green corrosion on this very critical connection I would say pop the pins one at a time, solder on new ones and see if you can order the original rubber sleave as well, to make the plug more water proof.
When new the plug was not open as pictured.

Martin

Post by **hippy chick** » 10 Sep 2012, 11:27

ooops i did try to solder it but melted the plastic

i have ordered one from peter cooper

so fingers crossed i will have it running by friday . The rubber cap is split so i will order that if they can get it. many thanks for all your help jen

Club 80-90 Forums

how do i fix this

how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this

Re: how do i fix this