Plastic fuel filler neck

[karmannkarmann]

Need to remove this to acces the edges for slight rust repair, undid the 3 screws but it won't budge and ideas how to remove it?

[jamesc76]

it twists a small amount to remove the top part, you also need to undo the top part from the neck

[Plasticman]

leave the 3 screws alone, undo/cut/remove the jubillee clip thaat holds mit to the neck , remove filler caap, find suitable sized open ended spanner and sit this in the opening so it fits in the 2 slots which the cap locks into , then use grips or another spanner and simply twist , only need about 1/4" and it will come free and job done
mm

[karmannkarmann]

Ok will give it a go, thanks for the tips

[Cyrus]

always worth checking the rubber pipe that attaches to it while your at it, it perishes and then lets water in from being sprayed by the front wheel.
I`d replace the rubber pipe, plastic part and metal ring that the three screws attach too all together using parts from brickwerks to save hassle later.