Hi
Is there a metal fabricator out there who could make a bracket for a pump. This is to secure an onboard pump for a boat. Requires 5 various size pieces welded together to form the required bracket.
Material has to be stainless steel (marine EN316 grade not necessary)
8mm plate thickness (for the design spec)
I have all the dimensions in PDF with construction details.
Size of plate total in area for this job would be less than 150mm X 300mm so not too large a piece.
If there is a willing person that would like to undertake this could you cost it and full payment for fabrication time, materials and postage would be paid if commissioned to undertake this task.
Thanks in advance
Fabricator challenge
Moderators: User administrators, Moderators
-
Steve T
- Registered user
- Posts: 163
- Joined: 05 May 2008, 10:02
- 80-90 Mem No: 5058
- Location: Salisbury, Wilts
Fabricator challenge
1984 1.9 DG Holdsworth Hi-Top
-
MattyGreg05
- Trader
- Posts: 143
- Joined: 21 Oct 2006, 06:43
- 80-90 Mem No: 3049
- Location: North Wales
Re: Fabricator challenge
Steve T wrote:Hi
Is there a metal fabricator out there who could make a bracket for a pump. This is to secure an onboard pump for a boat. Requires 5 various size pieces welded together to form the required bracket.
Material has to be stainless steel (marine EN316 grade not necessary)
8mm plate thickness (for the design spec)
I have all the dimensions in PDF with construction details.
Size of plate total in area for this job would be less than 150mm X 300mm so not too large a piece.
If there is a willing person that would like to undertake this could you cost it and full payment for fabrication time, materials and postage would be paid if commissioned to undertake this task.
Thanks in advance
I may be of use for this. Just email me
