JX Engine Data

[Evsi]

Hi all.

I've been giving the van engine a rebuild over the weekend and have looked everywhere for tightening torques/sequences with no luck. If anyone knows the following i'd be extremely grateful!

All JX TD;

Big end bearing cap nuts

Main bearing cap bolts

Head bolts (no instructions on the box!)

Cheers,

Jon.

P.S, i did find information on the wiki under "Diesel Engines", but i'm not sure if this is JX specific

[dave friday]

Hi Jon,I did a complete engine overhaul 3 years ago,I'll look up my notes and info.on my "jx" the big end bolts are single use stretch ones!!.
Any way I'll get back to you,good luck.

[Evsi]

Cheers Dave

[dave friday]

Right...
Bently,big ends standard bolts[9mm] 45nm,33ft ib ,stretch bolts [8mm] 30nm,22ft lb then 90deg .Just kampers the same!
Bently mains 6.5kgm,47ft lb .Just Kampers the same!
Bently head bolts 40,60,75nm,then 180deg or 2x90 with breaker bar run engine to 50 deg c then 90deg with breaker bar,600mls cold engine 90 deg with breaker bar
Just Kampers the same!
Elring,head bolts,40,60nm then 90,90deg with breaker bar, run engine to 50 deg c,90 deg with breaker bar,600miles cold engine 90 deg with breaker bar.
Any other info?

[Evsi]

That's awesome, thank you muchly for your help Dave! Engine all stripped and measured - in pretty good shape to be fair!