jk or gsf cv kit

Post by **libraryboy** » 07 Sep 2011, 13:07

got a bit of a conundrum and was hoping for some advice.

.

gonna replace all the cv's on my 1.9 and have looked online for kits.

jk £150
gsf £120

Has anyone got experience of either/both..good or bad ?

Post by **lloydy** » 07 Sep 2011, 14:01

I'd get them from brickwerks personally, they are GKN. Others are not very good from what you read on here
Lloyd

Post by **jamesc76** » 07 Sep 2011, 14:07

As lloydy said brickwerks are the way to go the others dont last ! Plus makes sure all the proper special washers are in place!

http://www.brickwerks.co.uk/shop?page=s ... gory_id=80

Post by **libraryboy** » 07 Sep 2011, 14:21

Cheers Guys..
I'm going to take your advice n grab a set from them ..Might put together a shopping list now.

Post by **weimarbus** » 07 Sep 2011, 15:54

I have used gsf ones one my trials buggy, they are made by lobro a gkn company and have been reliable so far running at a very acute angle ( the buggy is jacked as far as I dare go, the joints are running at 27 degrees so I would have no worries about using them on a standard T25, hope that helps

Post by **kit** » 07 Sep 2011, 18:25

Buy cheap buy twice.

Post by **weimarbus** » 07 Sep 2011, 18:38

kit wrote:Buy cheap buy twice.

Sorry but maybe I'm missing the point here but, gkn=oem lobro= gkn where's cheep

Post by **lloydy** » 07 Sep 2011, 18:42

weimarbus wrote:
kit wrote:Buy cheap buy twice.
Sorry but maybe I'm missing the point here but, gkn=oem lobro= gkn where's cheep

Problem with gsf is that they change suppliers, or stock two different suppliers, so it can be pot luck what you get. brickwerks only stock the good ones. Yours are the good ones

Post by **kit** » 07 Sep 2011, 21:42

weimarbus wrote:
kit wrote:Buy cheap buy twice.
Sorry but maybe I'm missing the point here but, gkn=oem lobro= gkn where's cheep

Cheep, isnt that what chickens do? :run

Post by **weimarbus** » 08 Sep 2011, 05:00

kit wrote:
weimarbus wrote:
kit wrote:Buy cheap buy twice.
Sorry but maybe I'm missing the point here but, gkn=oem lobro= gkn where's cheep

Cheep, isnt that what chickens do?

Apologies for the spelling, the sun was a long way over the Yard Arm

Club 80-90 Forums

jk or gsf cv kit

jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit

Re: jk or gsf cv kit