I need a new sliding door but how do i.......

Post by **Paul_Van_Denton** » 13 Aug 2011, 16:40

tell if its an early one i need? My van is a 1983 panel van. Will a later door fit with a later hinge or is it totally different? Are there any other differences?

These are the questions i've searched the internet for but couldn't find the answers.

Thanks alot.

Post by **jimpainter** » 13 Aug 2011, 17:39

Yours should be an early door. I think it was after 84 they changed.
Its a hell of a lot of work to change to a later door and will cost you loads to do it in the long run.

Post by **Paul_Van_Denton** » 13 Aug 2011, 20:00

ok thanks, its just hard to find a good early sliding door for my van. oh well ill keep looking

Post by **Plasticman** » 13 Aug 2011, 22:59

picky of the inside and out of the rot on yours and I will tell you wehter worth doing or not mike

Post by **Paul_Van_Denton** » 14 Aug 2011, 16:08

Post by **jimpainter** » 14 Aug 2011, 16:38

Quarter panel/arch as well i take it???????
If you got a straight door they would need doing, or......................you could fill them with filler

Jim

Post by **Paul_Van_Denton** » 14 Aug 2011, 17:28

yep i need a new quarter panel and arch aswell, its all buckled.....damn those devon roads!!

Post by **Paul_Van_Denton** » 14 Aug 2011, 17:30

so how exactly is the new door different? could i just cut the door hinge bar in half and weld the other half of a newer hinge to it? i guess im dreaming there but you never know.

Post by **Plasticman** » 14 Aug 2011, 21:07

well its a van door so certainly desireable and rarer, new bottom so the lower is easy enough to sort then some work on the dents and shouldnt then need too much filler. if you find a good door then do keep hold of this one as it still has value
mike

Post by **jimpainter** » 14 Aug 2011, 21:14

Paul_Van_Denton wrote:so how exactly is the new door different? could i just cut the door hinge bar in half and weld the other half of a newer hinge to it? i guess im dreaming there but you never know.

Not that easy im afraid. Alot easier to spend the cash on another door. There are good ones out there just not cheap. You could always try getting another door with a good bottom end and transplant it if needed.

Post by **Paul_Van_Denton** » 15 Aug 2011, 08:04

Ok thanks guys. Ive exhausted all the places i know for panels. Anyone know of somewhere to try and get a good door from? Anyone have one for sale here?

Club 80-90 Forums

I need a new sliding door but how do i.......

I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......

Re: I need a new sliding door but how do i.......