Where can I get

[mattrsa]

Stuff like in this picture to go round the cooker ( the sort of metal plating stuff)
http://www.flickr.com/photos/mattcripps/5824148516/" onclick="window.open(this.href);return false;
I have looked at the places I have got other stuff from but cant seem to find it

a point in the right direction would be great

[londonsoundbloke]

HI
Its hard to see from picture exactly what you're after. what size etc. but try searching the web for sheet metal. have a look at ebay item number 270764073920. or I would guess most of the big DIY places (homebase, wicks or B&Q) would do some smaller size pieces, but they probably will charge a lot more.

[mattrsa]

Thanks for that. It looks like the thing I might need. Will go see if b&q have a similar sort of thing.

[Ian Hulley]

Stainless steel sheet 3mm, as available from good steel merchants. Try ringing round and see if they'll guillotine a piece to size for you.

Ian

[Hacksawbob]

B&Q do that sort of stuff, but its monumentally expensive.

[Plasticman]

Ian, 3mm is a bit thick----------ish(1/8")
0.6 ,24g ish wuld do, call at a sheet metal type place, could always use thin zintec, dirt cheap
mike

[Red Westie]

Improvise.......buy something already cut and shaped of a similar size...like these perhaps:

http://cgi.ebay.co.uk/Stainless-steel-c ... 6673407ce1" onclick="window.open(this.href);return false;

http://cgi.ebay.co.uk/Stainless-Steel-W ... 82646db780" onclick="window.open(this.href);return false;

Martin

[bigherb]

Try a shop fitters they may have some off cuts left over from the last Kebap house the done.

[Ian Hulley]

Ian, 3mm is a bit thick----------ish(1/8")
0.6 ,24g ish wuld do, call at a sheet metal type place, could always use thin zintec, dirt cheap
mike

True, I was going all industrial again