Gearbox

[tonysbus]

I've just got the input shafts changed as i'm swopping to diesel. my question is do i need to change the release bearing shaft or can i just change the arm for the hydrolic clutch as the donor box was a manual clutch, also the bracket for the clutch cylinder will not fit now due to the starter position on the diesel set up is there a different bracket.

Thanks Tony

[Aidan]

diesel slave bracket is different to petrol one, yes you can just swap the lever arm off the end of the shaft if you can get it off

[billy739]

are you putting the whole early diesel / 1.6 petrol box in?

if so i think 50mph is flat out!

[Aidan]

no he's using the petrol abd box, just needs to swap over the bellhousing and input shaft and covert it back to hydraulic clutch

[tonysbus]

Thanks Aidan do you have the bracket and the arm knocking around as i have got the arm of the diesel bell housing but the petrol one is stuck but broken anyway.

Thanks Tony

[Aidan]

yeah all of that is on the shelf

[tonysbus]

Ok Aidan if you could pm me a price for them and a BH gasket n if you dont mind me bobbing over for them but it wont be till later this week as i'm on nights.

Thanks again Tony