Anyone have a base setting for the mixture/idle screws for 32-34 PDSIT as found on CU engines - I have a pair that have been totally stripped and rebuilt and wondered of there is a 2 1/2 screws out rough guide for them?..
ta
Doug
base settings for32-34 PDSIT
Moderators: User administrators, Moderators
-
dugcati
- Registered user
- Posts: 2004
- Joined: 15 Aug 2007, 18:23
- 80-90 Mem No: 3825
- Location: Debris
- Contact:
base settings for32-34 PDSIT
It is by will alone that I set my 'van' in motion!
-
steve8090
- R.I.P.
- Posts: 861
- Joined: 07 Oct 2005, 16:21
- 80-90 Mem No: 2
- Location: Member No.2 Club founder North Wales
- Contact:
Re: base settings for32-34 PDSIT
2 1/2 is not enough, try 3 1/2 as a base and you will not be far out, and the all important throttle base gap of 0.1mm then balanced to a throughput of 8.5 cu/in measured at tickover on a carb balancer
Steve Shaw
Club80-90 Founder Member
Full Service, LPG conversions, Security and Camper Accessories.
see http://www.gasure.co.uk for full details.
01244 659740
Club80-90 Founder Member
Full Service, LPG conversions, Security and Camper Accessories.
see http://www.gasure.co.uk for full details.
01244 659740
-
dugcati
- Registered user
- Posts: 2004
- Joined: 15 Aug 2007, 18:23
- 80-90 Mem No: 3825
- Location: Debris
- Contact:
Re: base settings for32-34 PDSIT
Cheers Steve - your wisdom is allways welcomed
E D I T - I've added this into the wiki 1/5/2011
E D I T - I've added this into the wiki 1/5/2011
It is by will alone that I set my 'van' in motion!