eber loom plugs, will it still work?

[lloydy]

or will i have to modify/link out some of loom, this is the controller

And these are the spare plugs on the back, can i just leave them as is, or do i have to link some of the wires out?

Any input would be great
Lloyd

[Oldiebut goodie]

Model? Then I could send you the wiring/manual.
And put some shoes on!

[lloydy]

Hi, thank for reply, its a D1Lc. Those two plugs both come off the back of the stat. I was thinking maybe one of them would go to a timer? and the rest maybe for sensors i'm not using?
And will hopefully be able to leave them as is, probably wishful thinking

And put some shoes on!

You wear shoes in my house and the wife will get you!

[Oldiebut goodie]

After perusing several diagrams the best that I can suggest is that the black connector containing the blue wire would go to a timer (but the yellow wire should be in the connector also). The other one appears to be for providing power to the heater when the ignition is turned off.(That's assuming that it has been wired up in the conventional way - but most people wire them up so that they run from the leisure battery anyway)
So basically you should be able to function as is.
Just test it on the bench - it should work albeit without a timer function.

[lloydy]

thanks for your time and help. Will post up when i have it running in about a week

[lloydy]

Got it running today, so all is good. Cheers for your time