size of bolt that bolts on the end pipe?

Post by **cubensis** » 13 Sep 2010, 11:12

Title says it all really, bolts are hammered between the backbox and the end pipe, got a 1986 1.9 dh, wondering what size these bolts where so i can get replacements when i drill the old ones out?

Post by **kevtherev** » 13 Sep 2010, 11:15

Post by **Red Westie** » 13 Sep 2010, 11:17

Well they are 8mm thread 1.25 pitch I think...just standard thread at that size (13mm head/spanner size)
The threads are in the silencer itself and if you are drilling out bolts you often just use slightly longer bolts with nuts.

Martin

Post by **kevtherev** » 13 Sep 2010, 11:41

M8 X 30 hex head

Post by **cubensis** » 13 Sep 2010, 13:36

Thanks alot!

Post by **Ian Hulley** » 13 Sep 2010, 13:42

When replacing the silencer it's common practice to drill out the threaded flanges and use nuts and bolts

Ian

Post by **kevtherev** » 13 Sep 2010, 13:45

makes life easier Ian
got some nice new ones here if you need them.. FOC just postage

Post by **cubensis** » 13 Sep 2010, 18:00

Thanks for the tip ian, sounds a good idea, so id go straight through with the bolt as pictured below?

http://picasaweb.google.com/lh/photo/0s ... directlink

Think ill take 3 of them off you kev, how much is postage? Also are they a little longer than M8x30 to accommodate the nut?

Post by **kevtherev** » 13 Sep 2010, 18:51

PM me your work address and I'll ship em (they have to be signed for...Courier)

I'll send a selection as you are nut and bolting

don't worry about postage...

Post by **cubensis** » 13 Sep 2010, 19:35

Pm'd, thanks again.

Club 80-90 Forums

size of bolt that bolts on the end pipe?

size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?

Re: size of bolt that bolts on the end pipe?