Been reading through various posts and am a little concerned about a couple of things:-
When I was checking my dizzy alignment last night, I removed the dizzy from the driveshaft and noticed that the fairly new seal I had put on from my mates (?!
) at JK had split into 2 parts. I decided therefore to fetch it out but after getting 1 half out, the other half disappeared somewhere into the depths 
. Is this likely to have gone into the engine and therefore will this be likely to cause damage or block my oilways? 
It was a flimsy rubber seal.Second thing - noticed lots of posts about fitting rocker gaskets and whether or not to use grease, sealants or not,etc. I recently replaced our gaskets and upon driving a mile up the road to get MOT'd, oil was p*%sing out. The garage advised me to use Tigerseal to fix this which I did and hey presto no more oil leak. My concern now having read some of the other posts is that this could also lead to blocked oilways? Is this a valid concerns or am I just being a tw@?
Thanks,
Chris
