Didnt get a full day today but got some done,
The sliderr is going to need lots of work but first will get it to fit right so I can set the nsr wing up, the slider allways dropped just as it was closing and sticks a bit so guessed the middle runner was worn,
Its not that bad but enough to cause the door to drop which caused the gap to not be parrallel,
A little weld and grind of and adjust the rear striker and ,great now parrallel at the front with an 8mm gap, at least I will now be able to fit the rear wing and gap it correctly.
The area above the middle runner replaced and a new piece let in the front, it wont be seen so didnnt let the patch in.
but this bit will be seen
![Image](http://i42.photobucket.com/albums/e308/mentalmick/body%20repair/IMG_3355.jpg)
so
I cut the old panal off before i had the new one so had to go by memory! yep I cut too much off so had to make this daft little bit
you only see the 1/8' on the right but it is the seam and would look carp if I didnt do it,
it goes behind the wing here
so were getting there,wing trial fit ok
Just found this old minimax extinguisher, filled it with water and it works a treat, ran out o 1/16 rods so welding a bit larger than Id like but it will do, finnish inner arch tommorow and then fit the wing and on to the other side for a repeat-ish
mike