I need a brake back plate for saturday. Am after rear near side for an 82 air cooled..can anyone help in the notts/derby area for me to get hold of one as GSF don't stock them?as far as I know..
I appreciate what you are saying, will probably opt for jk cheaper by £100 and hundred and fifty on top of two swing arms, plus labour and van tax in one month is why I was hoping for a second hand brake plate, as have just had new shoes, pads, cylinders etc..
S/h back plates are likely to be as bad or soon to be as bad as yours are. If you've seen the Brickwerks ones (and I fitted 2 to our van recently) they are VW standard, galvanised and very heavy. The real shock was how thin the old ones were and they'd just rubbed through on 1 contact point each.
Ian
The Hulley's Bus 1989 2.1DJ Trampspotter LPG courtesy of Steve @ Gasure
I have just changed my back plates as they fell apart also, I used JK back plates they are good quality and fit well, heavy gauge but not galvanised I used hammerite undercoat and top coat to protect and so far no rust!
Applologies men. Your right Rob and I was very wrong, where the hell did I get £35 quid from ?
Must have had a silver haired moment. Just cant understand why backplates are so expensive, very important part I know but compare them to a set of brake discs with all the machining involved it just doesn,t seem right. I have just replaced discs, pads drums and shoes on my old Cavalier for under £130 !
peteabbott wrote: I have just replaced discs, pads drums and shoes on my old Cavalier for under £130 !
Which isn't weight rated at 1 let alone 2.4 Tonnes. The backing plates are a critical part of a critical safety system on a potentially heavy van, the back brakes are very good on these vans and looked after properly work very well.
I personally wouldn't think that the GSF or JK plates will be OEM VW but it's your van so you do what you wish.
Ian.
The Hulley's Bus 1989 2.1DJ Trampspotter LPG courtesy of Steve @ Gasure
Yup your 100% right, not disputing that at all, you would be a fool not to agree but I suppose it is just the way things are. I have worked in a press shop and seen backplates stamped out in two operations.........done and yes very very important but that does not in my opinion justify the high cost, I am just a tight grumpy old man !