Accelerator is very stiff - how to take it off?

Big lumps of metals and spanners.

Moderators: User administrators, Moderators

Locked
User avatar
ringo
Trader
Posts: 2245
Joined: 14 Oct 2005, 05:41
80-90 Mem No: 1375
Location: Nottingham

Accelerator is very stiff - how to take it off?

Post by ringo »

In the last very cold snowy spell, the accelerator pedal seemed stuck - i pushed it down and it free'd.

However, ever since then the accelerator has been sticking.

I had a look today and its not the cable - its the accelerator mechanism hinge that attaches to the floor pan but from underneath (the bit that the end of the accelerator cable slots into).

I've applied some plus gas and some oil - but its not freeing up.

Are there any tips on getting the thing off? Its bloody annoying.

Cheers,

Ringo
Now driving a big bad VW LT Florida.

silverbullet
Trader
Posts: 17231
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Accelerator is very stiff - how to take it off?

Post by silverbullet »

It's a pig of a thing - You can only just see it from under the van anyway. Break both your forearms first, it'll make the job of dismantling it easier :lol: (The earlier ones have an adjustable stop for full throttle fyi)
You will need a good bright headtorch too!
Oh yeah - the outers go brittle and break into lots of bits :evil:
Last edited by silverbullet on 09 Feb 2010, 17:22, edited 1 time in total.
1985 Oettinger 3.2 Caravelle RHD syncro twin slider. SA Microbus bumpers, duplex winch system, ARC 7X15 period alloys

User avatar
axeman
Registered user
Posts: 1249
Joined: 07 Feb 2009, 19:50
80-90 Mem No: 6410
Location: Smeeth kent country side

Re: Accelerator is very stiff - how to take it off?

Post by axeman »

i had the same problem when the cold spell started a month or so ago, it turned out to be the cable was rusted and had quite alot of crap with in it. by that i meaqn the white nylon coating that the inner metle cable sits with in. i ended up replacing the cable and the outer sleaving (adian has the sleaving),and the result inpresed me a lot , it must have always been stiff it was not untill i compleatly re did it that i worked out how it should be. i dont want to question where you say the falt is but from what your discription the part should be fairly free as there is a bolt or pin of sorts that the mechinisum hinges on efffectively. i would look again at the cable and the outer sleaving.

hope this helps neil
Back in the game with an uncut 2wd panel van

User avatar
ringo
Trader
Posts: 2245
Joined: 14 Oct 2005, 05:41
80-90 Mem No: 1375
Location: Nottingham

Re: Accelerator is very stiff - how to take it off?

Post by ringo »

Thanks guys,

I loosened the cable and that seemed free enough. I changed it last year so it should be fine.

Does the hinge connect with a circlip or a nut? Can i take the whole lot off or is it welded?

Thanks

Ringo
Now driving a big bad VW LT Florida.

User avatar
gti mad man
Registered user
Posts: 1020
Joined: 20 Jan 2008, 22:42
80-90 Mem No: 4918
Location: London

Re: Accelerator is very stiff - how to take it off?

Post by gti mad man »

im sure the actual plastic pedal is riveted to the floor and the linkage bolts up?
Holdsworth villa 3 1987

Andy

User avatar
windysurfer
Registered user
Posts: 996
Joined: 14 Jun 2007, 18:58
80-90 Mem No: 3805
Location: Lancashire

Re: Accelerator is very stiff - how to take it off?

Post by windysurfer »

Picture for ya
Image
If Carlsberg made Coachbuilts...........Image T4 Karmann Colorado

User avatar
ringo
Trader
Posts: 2245
Joined: 14 Oct 2005, 05:41
80-90 Mem No: 1375
Location: Nottingham

Re: Accelerator is very stiff - how to take it off?

Post by ringo »

Gaz - you're a legend :)

I need a circlip then!

God knows how i will get it back in - i better buy two!

Ringo
Now driving a big bad VW LT Florida.

User avatar
jamesc76
Registered user
Posts: 6241
Joined: 14 Oct 2005, 14:42
80-90 Mem No: 1186
Location: Nottingham
Contact:

Re: Accelerator is very stiff - how to take it off?

Post by jamesc76 »

can you get at it once the indicator is out ??
DJ at Dubdayz Summerfest
Now cutting about in an LT35 MWB

User avatar
ringo
Trader
Posts: 2245
Joined: 14 Oct 2005, 05:41
80-90 Mem No: 1375
Location: Nottingham

Re: Accelerator is very stiff - how to take it off?

Post by ringo »

jamesc76 wrote:can you get at it once the indicator is out ??

Maybe :ok

Ringo
Now driving a big bad VW LT Florida.

Locked