It is a loom of some kinda that goes up into the cockpit, though there was hardly any way of moving or getting slack in it. I trimmed the rubber boot to make it slightly thinner & get slight bit of slack. However took a bit of effort to get the O/S frame in and the headlight mounting frame is right up against the loom. I had to flex & bend the frame tabs a bit to make it fit, so not ideal!
Is it possible that the loom should have been put into item 2 (grommet) at the factory & this a factory build error, but never been discovered until attempting to fit twin headlights? If it had then the loom would of fit behind the frame ok, as then it would be sitting behind the more taped bit of the mounting frame.
Has anyone else had this problem when fitting Twin headlights frames? The frames are RHD and are genuine VW. The mounting frames are in though not looking forward to taking off O/S one in future to replace any bulbs.
Any information is appreciative.
[/img]
