Stupid question

[mikec]

I'm about to put a Rock and Roll bed in my van, hinges on way from JK. What size foam should I be getting? Should the back and base foam be the same length? (Uh width? - lenght if you think of it as a bed! ) or one longer and one shorter so they sit right when it's a seat?

Any ideas?

Thanks

Michael

[kevtherev]

mine has 4" high density on all

[minke]

Ask JK they gotta a wiki site & just a phone call away.

[Gunslinger]

mine has 4" high density on all

Same here

[toolsntat]

One longer ,one shorter on my Reimo & Holdsworth r&r beds....

Not sure which way round but would figure to have back sitting onto base to allow for any lap belts

Do the back n base first and then in bed form measure the rear section so as to keep its continuity through to the back....

[mikec]

One longer ,one shorter on my Reimo & Holdsworth r&r beds....

Not sure which way round but would figure to have back sitting onto base to allow for any lap belts

That makes sense!

Do the back n base first and then in bed form measure the rear section so as to keep its continuity through to the back....

That makes sense too but I''m trying to be clever, closing off the back to keep as storage space and having the bed extend onto a lowered table in front instead. At least that's the plan...

...watch this space

[jamesc76]

Good idea but there might not be enought room to make the bed up and actually get into it !!!

[mikec]

Good idea but there might not be enought room to make the bed up and actually get into it !!!

Well, where's your sense of adventure?

I'll see how it works, it seems like a good idea in theory...

[kevtherev]

Ah re read it and ..
yes I have the back 4" shorter than the base

[mikec]

Ah re read it and ..
yes I have the back 4" shorter than the base

Thanks for that, makes perfect sense.