Brickwerks Suspension Shims

Post by **Dubstar** » 15 Mar 2009, 16:54

Just putting the rear one on - do the grooves face up towards the chassis or down towards the rubber and the top of the spring?

Post by **jason k** » 15 Mar 2009, 18:01

groves down. flat surface to the top. turn the shim so the flatted off face faces to the tyre

Post by **Simon Baxter** » 15 Mar 2009, 20:25

Smooth side down, grooves up.
Just put it on so where it says "brickwerks" you can read it.

Post by **badger** » 15 Mar 2009, 20:47

jason k wrote:groves down. flat surface to the top. turn the shim so the flatted off face faces to the tyre

Looks like you might need to turn your shim over Jase?

Post by **Dubstar** » 15 Mar 2009, 21:08

Get in there - I did it the right way after all!! It was in bits and getting dark so I took a chance and did it the right way, so Brickwerks is the right way up. Thanks guys.

Post by **jason k** » 17 Mar 2009, 08:25

badger wrote:
jason k wrote:groves down. flat surface to the top. turn the shim so the flatted off face faces to the tyre

Looks like you might need to turn your shim over Jase?

doh!!!

Club 80-90 Forums

Brickwerks Suspension Shims

Brickwerks Suspension Shims

Re: Brickwerks Suspension Shims

Re: Brickwerks Suspension Shims

Re: Brickwerks Suspension Shims

Re: Brickwerks Suspension Shims

Re: Brickwerks Suspension Shims