Went to Elite today...

Post it here, if it doesn't fit any of the above.

Moderators: User administrators, Moderators

Locked
User avatar
ermie571
Registered user
Posts: 4970
Joined: 11 Oct 2005, 11:11
80-90 Mem No: 2129
Location: Minster-on-Sea, Kent: Member 2129 07784052288

Went to Elite today...

Post by ermie571 »

And found out that the hiccupping we were experiencing on gas, and the erratic idle were due to a lack of a shim underneath the distributor!! :shock: Both Mick's amazed that it was running at all...and even more gobsmacked when we said that we hadn't had the dizzy off in the 3.5 years we have had her!!

gas service done (filter changed, valves checked and system set up)
Dizzy removed (was 180 degrees out), shims fitted and dizzy replaced

Couple and bit hours.

Total charge £40! :D

Hopefully, with the shim on the damage done to the engine block by the distributor will not be noticeable, as the shim is wider than the hole the dizzy has made :shock:

Oh, and had a play with the laser thermometer...... 96 at the block behind fuel pump, 76 ish on the manifold, 46 at the thermostat housing and 24 ish at the rad!! Hottest was front right as you look at it where exhaust header is as the oil is hottest there apparently and you have the exhaust too! Was around the 100 mark there.

IF anyone knows where I can get a accelerator pump diapragm I would be greatful...1990 2.1 running 1.9 carb. Apparently its letting by a little.

Take care,
Em
x
2.1 DJ 1990 Caravelle (died and gone to heaven)
2.0 AGG (1997 ish) 1984 transporter LPG

User avatar
VWCamperfan
Registered user
Posts: 993
Joined: 08 Jul 2007, 19:47
80-90 Mem No: 4000
Location: Sheerness, Kent.

Re: Went to Elite today...

Post by VWCamperfan »

Shims...??! :shock: I didn't know they had them! Mine hasn't got any, might have to look into that one just to be on the safe side!

Good to hear you're running smoothly again. Cant find any rebuild kits for that carb though, thought there would be at least one on the net somewhere but no... Typical! I'll keep looking!
Mark.

I'm Not A Complete Idiot... Some Bits Are Missing!

1.6 Modified CT engine.

User avatar
R0B
Moderator
Posts: 19430
Joined: 07 Oct 2005, 17:33
80-90 Mem No: 864
Location: Cheshire

Re: Went to Elite today...

Post by R0B »

something tells me your engine would not be running right if this was so...

Dizzy removed (was 180 degrees out)
2.1 LPG/Petrol Auto Caravelle

"The difference between genius and stupidity is that genius has its limits"

User avatar
Mocki
Membership Admin
Posts: 17269
Joined: 29 Sep 2005, 09:27
80-90 Mem No: 428
Location: Mansfield Notts
Contact:

Re: Went to Elite today...

Post by Mocki »

180 degrees out is a common thing with rebuilds , just means you have to put the plug leads 180deg out on the cap to correspond.
Steve
tel / txt O7947-137911
👀
________________

1989 2.1LpgWBX HiTop Leisuredrive Camper
1988 2.1 Auto Caravelle TS TinTop Camper 
 

User avatar
tonytech
Registered user
Posts: 1194
Joined: 11 Oct 2005, 06:40
80-90 Mem No: 477
Location: Liverpool

Re: Went to Elite today...

Post by tonytech »

Interested in the thermometer readings. I've got a non contact thermometer and I'm trying to check if my engine is warming up OK. My dash guage is working, but seems to register 1/3 at normal running.
I'll compare yours to mine.
Ta
Tony
There are 10 kinds of people. those who understand Binary and those who dont

User avatar
ermie571
Registered user
Posts: 4970
Joined: 11 Oct 2005, 11:11
80-90 Mem No: 2129
Location: Minster-on-Sea, Kent: Member 2129 07784052288

Re: Went to Elite today...

Post by ermie571 »

Tony - glad they were of use to you. They were taken after a run. Sitting at protracted idle, the rad got to 60 I think, but we didn't do any engine readings. Needle at time of readings was just over half, and was thought to be possibly reading a little high. All the way home it hovvered around the halfway mark.

Mark - yep shims, or I think, shim. You wouldn't believe how quickly that drive came out once the fuel pump and needle and long bit of plastic was out.... Check the two studs underneath the dizzy....you could see where mine have been "chipped" or worn. Dunno what the drive looked like as the two Micks were busy oggling it!!!

Em
x
Note: Please, if you are using the temps as a guide, please do not treat them as gospel. I am going on memory, and cited them only to show the difference in temp accross the engine!
2.1 DJ 1990 Caravelle (died and gone to heaven)
2.0 AGG (1997 ish) 1984 transporter LPG

User avatar
Aidan
Trader
Posts: 7029
Joined: 11 Oct 2005, 19:21
80-90 Mem No: 742
Location: Llanfyllin, mid Wales : )
Contact:

Re: Went to Elite today...

Post by Aidan »

thrust washers 2 off suprisingly expensive things to protect the case, vw rebuilds came without the disidrive fitted and I bet peeps don't always transfer them over correctly, and lots of rebuilds from certain places seem to come 180 degrees out, which is a simple matter of care, if they can't get that right what's the rest of it likely to be like ?

User avatar
ricicles
Registered user
Posts: 934
Joined: 16 Mar 2008, 17:47
80-90 Mem No: 6350
Location: wymondham

Re: Went to Elite today...

Post by ricicles »

got a complete 2e3 all the diaphrams are ok. some new ones( choke pulldown) and a new idle shutoff. you can have it if its of use to you.

User avatar
dugcati
Registered user
Posts: 2004
Joined: 15 Aug 2007, 18:23
80-90 Mem No: 3825
Location: Debris
Contact:

Re: Went to Elite today...

Post by dugcati »

can you post some pics of the shims? I am very interested to see this as I have never heard of shimming a distributor before
It is by will alone that I set my 'van' in motion!

User avatar
johnnyvespa
Registered user
Posts: 266
Joined: 11 Nov 2008, 10:53
80-90 Mem No: 6131
Location: essex
Contact:

Re: Went to Elite today...

Post by johnnyvespa »

is that the elite in basildon ?? . are thay any good as i want a service , i dont live far from them
mem 6131 . :ok
hello i am john and i am looking forwored to metting outher 8090 members

User avatar
ermie571
Registered user
Posts: 4970
Joined: 11 Oct 2005, 11:11
80-90 Mem No: 2129
Location: Minster-on-Sea, Kent: Member 2129 07784052288

Re: Went to Elite today...

Post by ermie571 »

You have pm!

Em
x
2.1 DJ 1990 Caravelle (died and gone to heaven)
2.0 AGG (1997 ish) 1984 transporter LPG

Locked