heater splitting

Post by **TOMMY THE CAT** » 21 Jun 2006, 21:53

I have got the dash out took all the clips off the two halves but seems to be stuck fast along the windscreen edge have I missed something? Didnt want to get too heavy handed untill I new it was just stuck...there is mastic sealing it as well as the clips. ta D

Website · Post by **CovKid** » 21 Jun 2006, 21:58

If the motor is dead (try turning it by hand) its WAY easier to just put in a complete second hand box. Mine wasn't stuck in with mastic but did need a little leverage to shift it. You mean you got the four screws out with no prob??? wow....

Post by **TOMMY THE CAT** » 22 Jun 2006, 16:07

Been a piece of pish apart from splitting the case.......even the shear bolts have already been changed.....havent took the bolts out yet holding the heater box to the front of van was hoping to split the case in situ (bottom from top)????? at D

Post by **Mocki** » 22 Jun 2006, 17:01

TOMMY THE CAT wrote:Been a piece of pish apart from splitting the case.......even the shear bolts have already been changed.....havent took the bolts out yet holding the heater box to the front of van was hoping to split the case in situ (bottom from top)????? at D

thats why you cant gerrit aprt, you have to remove it from the van first iirc......

Post by **TOMMY THE CAT** » 22 Jun 2006, 19:20

Thanks Mocki just been to the van and worked that out!!!!! I thought I may be able to seperate it in the van but not seeing the inside gubbins.... obviously not poss. Two questions a, Wiki says about 4 screws in the cab two above lights behind gril???? Cant see them on my van and the unit seems loose? b , Do the heatercables have to be diconnecred at the lever ends? To me it looks like they will as my main loom goes through the cables!? Doh Want to replace some of the cables anyway so will have to label them welll or gonna be it the dog doo.

Dave 1.6 d
Ps lucas or partco what or who are they as i have been told will get a voltage stabaliser from them. Ta d

Website · Post by **CovKid** » 22 Jun 2006, 21:02

I only found the four main screws on the unit held it in place. Are you sure you really want to open the box though?

Before you do that, pull it forward so you can get to the fan from the back and see if its seized first. Mine was and a few squirts of WD40 and a couple of turns by hand and it was away again.

By the way, shear bolts on column will generally shift with molegrips and put back in the same way.

Post by **TOMMY THE CAT** » 23 Jun 2006, 21:15

shear bolts already had been removed before I got to it

just got to plug the pipes and remove....damn football gets in the way all the time!

D

Club 80-90 Forums

heater splitting

heater splitting

yup

Re: yup

T A