Inertia rear seatbelt fitting advice please.

Post by **camper** » 06 Jun 2006, 13:30

I have a 1981 devon conversion Aircooled.There is a lap belt for one person and a inertia seatbelt that is not fitted.I noticed at the rear there is a seatbelt bolt screwed in at the nearside and a threaded hole in the door piller inside near the sliding door runner.Behind the rock&roll seatbed there are screwed holes to accept the seat belt connector.Any advice as to the correct way to install a rear inertia seatbelt appreciated thanks.

Post by **Hacksawbob** » 06 Jun 2006, 14:56

do you want three point or 2 point? two points can easily swap in for the existing, three points may need a bit of drilling.

Post by **camper** » 06 Jun 2006, 15:34

The inertia seatbelt has reel fitting and two points .I guess that makes it a three point thanks.