panel van interior problems

Post by **angry vanagon** » 07 May 2006, 22:18

Wondered if anyone could shed light on my interior problem got a 1990 RHD panel van which i am in the process of fitting a interior to. When i bought the van it was fully boarded out but the side panels did'nt fit to well around the roof and they needed covering in trim so i removed them, when i removed the two rear most panels next to the rear door to my suprise they were all pressed for windows and interior trim so my plan was to use factory caravelle trim for the lower half and make blanks to fit the window apperture's when i removed the board from opposite side to the sliding door the inner window frame was missing and the pressings were there for a right hand sliding door. so how do the camper converters who cut windows out in panel vans get round this? i have looked on ETKA but the pictures are poor,it looks like there is some kind of inner window panel? has anyone ever seen these or fitted these? thanks andrew

Post by **scoobydrew** » 07 May 2006, 23:32

Andrew,
We fitted one in our old panel van, not sure if it was out of a Velle or not.
They are available but don't come up very often. Try one of the breakers in the club.
We screwed ours into place but I supose you could no nails it in for a smoother finish.

Post by **hakuna matata** » 08 May 2006, 15:30

hi call me ive got one it fits the other side from sliding door its called the inside frame, screw it on , / pop rivit it on ,/ glue it on , take your choice.
neil; 07973-151117