Hi all,
Trying to find out what offset (if any) is between the surface of the crankcase (where the bellhousing bolts to) to the surface of the crankshaft (flywheel side) ?
I've decided to attempt to make an adapter plate to install my diesel PUG engine because can't seem to buy one anywhere...
Any info will be much apreciated.
Cheers
Aussie_B
Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Moderators: User administrators, Moderators
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
hi just seen your post.
i am having a plate made at the mo , but the plate alone is going to be 300£
doing this after 3 people have asked for one!
a flywheel costs 100£
only thing ive not sorted yet is the spigot bearing carrier.
the plate is one of phills i have as a spare which is being copied!
i am having a plate made at the mo , but the plate alone is going to be 300£
doing this after 3 people have asked for one!
a flywheel costs 100£
only thing ive not sorted yet is the spigot bearing carrier.
the plate is one of phills i have as a spare which is being copied!
-
andysimpson
- Registered user
- Posts: 213
- Joined: 19 Oct 2005, 21:15
- 80-90 Mem No: 0
- Location: Chorley, Lancs
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
billy739 wrote:
the plate is one of phills i have as a spare which is being copied!
Make sure whoever copys it is pissed, it might line up properly then.
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
the plate was in a van for quite a few miles 30000 ish to be sure!
no issue's at all so no problem with alignment!
no issue's at all so no problem with alignment!
-
andysimpson
- Registered user
- Posts: 213
- Joined: 19 Oct 2005, 21:15
- 80-90 Mem No: 0
- Location: Chorley, Lancs
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
billy739 wrote:the plate was in a van for quite a few miles 30000 ish to be sure!
no issue's at all so no problem with alignment!
Not like the one i had the misfortune of coming accross then.