WHO CAN MACHINE AUDI WHEELS IN THE CORNWALL AREA ???

Post by **sxboy** » 08 Nov 2008, 20:50

Hi, I have a set of Audi A8 wheels that I need the centre bore taking out to 66mm.
Does anyone know who can do this in the Cornwall (Redruth) area.
Thanks

Post by **kooldubs** » 10 Nov 2008, 11:05

your best bet is to put engineering shop in your local area in yell.com and see what comes up chap...i know thee is quite a few in plymouth but they charge roughly £20-£25 per wheel

Post by **futbus** » 12 Nov 2008, 19:38

Were a bit further away in south devon, but we only charge £50 a set if the tyres are removed.

Give us a call if you need any help.

Post by **Westy.Club.Joker** » 15 Nov 2008, 18:04

If you get `em wacked out to 66mm the centre caps won`t fit afterwards. I usually machine `em less and sort out the offsets, grease caps etc to try and keep the original caps.

What width of rims are they? What is the offset? (ET)

See here for info from the Brickyard:

http://homepage.ntlworld.com/michaeltyl ... t_Data.htm

I charge £15 per wheel for the two fronts only, or £50 for a full set of 4 (tyres on or off)

Get the 2 fronts rims (without tyres) couriered to me for not a lot of money, i`ll do `em and send `em back