1.6 derv poor / slow starting /turn over

Big lumps of metals and spanners.

Moderators: User administrators, Moderators

Locked
steve o
Registered user
Posts: 63
Joined: 04 Oct 2008, 21:14

1.6 derv poor / slow starting /turn over

Post by steve o »

HI
my 1.6 derv (original petrol) is difficult to start now mornings are
cold / damp,
replaced heater plugs, heater selinoid,battery fully charged,
take a good 60 secs with finger on heater plug switch /button,
befor it will start,any thing else i could check?
thanks
steve.

peteabbott
Registered user
Posts: 332
Joined: 24 Jan 2008, 17:40
80-90 Mem No: 4672
Location: Ipswich

Starting

Post by peteabbott »

Hope this is not a silly question but are you pulling out the cold start/chokey thing that apparently advances the timing and or richens the mixture ?? Don,t think the push button on your dash is standard and I think it is OK as long as it heats the hot plugs via a relay as some I have seen have high current cables right upto the dash.........not good practice.
Pete Abbott

steve o
Registered user
Posts: 63
Joined: 04 Oct 2008, 21:14

starting

Post by steve o »

HI
the button on dash is conected via relay ect,to heater plugs,to
help with cold start,
thanks
steve.

kit
Registered user
Posts: 2122
Joined: 17 Jan 2007, 21:01
80-90 Mem No: 4170
Location: Southampton

Post by kit »

Mine will not start without the advanced lever out, when it is out it fires up first time :)

steve o
Registered user
Posts: 63
Joined: 04 Oct 2008, 21:14

Post by steve o »

HI
as mine dose,nt have advance lever,
presume the button an dash does the same job?
thanks
steve.o

peteabbott
Registered user
Posts: 332
Joined: 24 Jan 2008, 17:40
80-90 Mem No: 4672
Location: Ipswich

Post by peteabbott »

I am not an authority on this, just another one time cold start refugee ! Two things assist cold start one being heater plugs and this alone was not much help. Then someone on this forum pointed out "the chokey thing" I was expecting to find a knob to pull but then as if by magic there it was, just in front of my left knee 3" X 2" square...........how did I miss it ? Mine just will not start without it, even when hot it fires up quicker. Mine is an 87 1.7 and I dont know if they were fitted to all diesels but there again if yours was previously a petrol I would have thought that what used to be a choke cable would have been hooked up to the advance mech on the pump. Take a look under the rocker box side of the pump..is there an arm there not hooked up to anything ? If there is how about tying it forward and see if it works.
Good luck in your search.
Pete Abbott

steve o
Registered user
Posts: 63
Joined: 04 Oct 2008, 21:14

starting

Post by steve o »

Thanks
will do,steve.o

Locked