Lumpy acceleration LPG Conversion

Post by **Daisy** » 27 Oct 2008, 09:08

I have a 1.9 Petrol engine with an LPG conversion which was done by Steve at Gasure 2 years ago (ACE BIT OF KIT) my question is are the any filters on the Gas (fuel lines that require attention at any time, my reason for asking is that my van gets a little lumpy on acceleration when hot.

I will be replacing the plugs which i believe should be a single point plug set at with a gap of 25
, and if there are filters in the gas lines i will attend to those at the same time.

Thanks for any tips

Post by **ermie571** » 27 Oct 2008, 09:34

Daisy,
yes there is a filter.....speak to Steve...he will advise on whether lumpy acceleration is due to this or not.

Em
x

Post by **Daisy** » 27 Oct 2008, 10:00

Thanks it says in the wiki to contact steve via the club doe`s that mean he may see this and reply or is there another avenue.

I know i could phone him but i know if somebody is busy phonecalls with queries allways come at a bad time

Post by **ermie571** » 27 Oct 2008, 10:21

Daisy - pick up the phone and give him a call....that seems to be his preferred method. I am sure that if he is busy he will let you know?

Em
x