Just measure up where you want the hole, and then check underneath to make sure there is nothing in the way. Just infront of the rear jacking points is a popular place, with no complications underneath.
ringo wrote:Im not too familiar with propex's but something sounds not quite right here...
Where are you going to put the propex?
If under the rock and roll bed, then surely the only holes you need to drill through the floor are inlet, exhaust and possible gas supply (and possibly power) ? These are all relatively small holes which should be sealed by the gasket on the propex.
Dont you just need 2 x 63mm holes cutting through the front of the bed to direct cold air in and warm air out?
Unless of course you are planning to duct the hot air to a completely different place?
I've probably got very confused - so sorry if im completely wrong!
Ringo
ringo
the propex is already in I have bought more ducting ans switchable Y branch so i can direct heat to the front of the van then to the back by switching the Y branch when parked
Just measure up where you want the hole, and then check underneath to make sure there is nothing in the way. Just infront of the rear jacking points is a popular place, with no complications underneath.
many thanks syncrosimon
ive got the arbor & hole cutter, will try the sealant you suggested, ill post a few pics when Im done
its actually another ducting hose I am planning on installing with a switchable Y branch to i can heat the front while driving and the back while camping
cheers
irishkeet
ps: love the colour of your van, mine is a slightly lighter green, great colour for a camper
ringo wrote:Nice one. Does it work? (ie does it clear your windows?)
Ringo
will have to wait for a cold day to test, today was beautiful!
but there is a good blast of hot & cold coming from the front
will post a thread with some pics
1680]http://i199.photobucket.com/albums/aa28 ... 0734-1.jpg[/img]
