Technical Recommendation - Journeys under difficult...

Post by **Boltze** » 11 Feb 2006, 14:46

conditions.

Now online on http://www.vwpix.org

Here the direct link: http://vw.dnsx.de/archive/leitfaeden/19 ... onditions/

Not only for 4WD T25.

Post by **stuckin88** » 12 Feb 2006, 07:28

Cheers Christoph!----interesting reading---

Post by **Simon Baxter** » 12 Feb 2006, 18:28

This will be usefull for CJ

Post by **HarryMann** » 20 Feb 2006, 00:00

Presume missing pages 6, 8 & 10 are blank?

Post by **SyncroSam** » 20 Feb 2006, 17:42

Not blank no, as the pages don't follow on from each other where there are missing ones, and unusual to have blank pages in the middle of an article!

I presume they are missing because Christolph doesn't have them.

Sam.

Post by **HarryMann** » 20 Feb 2006, 19:20

Nice to know its incomplete then

Post by **Boltze** » 20 Feb 2006, 20:42

Yes this is right, i'm sorry for that, i'll ask Joel for the other ones.

Post by **HarryMann** » 20 Feb 2006, 21:52

No problem, just wanted to know the score, and it is very handy to have those pages now... hope you don't mind me saying that one or two of the drawings are just a shade under the resoltion needed to read all the specs and mfring info. They're good, and 95% readable, but if you want the material heat treat spec for instance, in the blueprint's Mat'l Defn. box, that's hard or impossible to read - as engineering blueprints are normally drawn in two or three different line-weights, and the lighter ones sometimes don't show well...

Had this with a complete set of decoupler drawings, a very complex set, and it nearly drove me mad, knowing I had a rare set of drawings, but doubly difficult being in German, struggled to get some of the dimesnions and material specs out of them - so effectively gave up.

Cheers

Post by **Boltze** » 21 Feb 2006, 16:38

I uploaded the missing three pages, now it's complete.

HarryMann if you need a bigger resolution, i give you the mail adress of the guy who has the original recommendation.

Post by **HarryMann** » 21 Feb 2006, 18:02

Thanks, I would like that, at least for the drawings, just a bit more would be fine.

In the meantime I'll grab those other three