1.6T/D to 1.9 diesel

Post by **Snag20** » 25 May 2008, 07:55

May be forced to scrap my 1.6T/D engine

looking to swap to a 1.9diesel either n/a 1y or T/D AAZ

which would be easier ?

read lots of info on here but could do with a summery

It is my understanding I use my 1.6sump

If I go the 1 Y route which inlet/exhaust manifold ?

If I go the AAZ route which inlet/exhaust manifold ? do I use the donner car s and get an exhaust made to fit ?

please help as seen a Toledo I may wish to use a an AAZ doner
cheers
Trev

Post by **camper** » 25 May 2008, 08:22

Is the 1.6td beyond repair ? I recently converted to a 1Y 1.9n you can swop your sump over blank off the turbo return pipe inlet on it.Or exchange for a 1.6n as its sought after for AAZ conversion.Fit the 1.6td oil pump with is pick up.Manifolds inlet&exhaust down pipe +exhaust 1.6n.On my conversion i used the 1Y exhaust manifold and fabricated the 1.6td down pipe from it to the 1.6td exhaust pipe& used a 1.6n inlet manifold +airbox.Use the 1.6td flywheel&clutch fit a spigot bearing to the crankshaft for the gearbox input shaft .AAZ going to be easier as you have nearly a sraight swop of 1.6td parts to it.

Post by **Snag20** » 25 May 2008, 09:21

cheers Camper

pls see my other post-- over reving diesel--fo info on my1.6T/D
cheers

Post by **camper** » 25 May 2008, 10:29

If the turbo on your 1.6td is worn or other issues a conversion to AAZ is going to need these parts. You could use the AAZ turbo but its in a diffrent position as to cause clearance on the engine mount issues.Find out what is wrong with the 1.6td and read up on the wiki on the forums there is a lot of information as to a solution.

Post by **SplendiferousII** » 25 May 2008, 10:41

Hi Snaggs. I wont try to influence your decision on the way to jump. The offer to pop over and give my 1Y conversion a run is there for the taking. See if you can live with the speed.

Treve