Gearbox dilemma!!

Big lumps of metals and spanners.

Moderators: User administrators, Moderators

Locked
User avatar
Chopper
Registered user
Posts: 24
Joined: 15 Jun 2007, 13:55
80-90 Mem No: 5656
Location: West Cork, Ireland
Contact:

Gearbox dilemma!!

Post by Chopper »

The clutch has gone on my wagon and the gearbox has to come out so I'm trying to figure out the following.
My van was originally a 1600 plain Diesel, now upgraded with a 1900 Caddy motor.
Top speed is not great with this set up and I've been told that this is not a good engine/gearbox combination.

With a little bit of messing about I can get my hands on a 5 speed box from a 1900 Wasserboxer panel van.
Would this be worth the hassle and give a better final drive ratio?

Any advice would be greatly received!!

Laurie
Trader
Posts: 26
Joined: 03 Feb 2008, 19:55
80-90 Mem No: 0

Post by Laurie »

Not really. The petrol engine supplies power at far higher revs. Meaning the diesel runs at the same speeds at lower revs. I think you may be into a bespoke box if you want to match it properly.
Laurie Pettitt-Engines.

07824514205

User avatar
toomanytoys
Trader
Posts: 2872
Joined: 11 Oct 2005, 18:37
80-90 Mem No: 41
Location: Boston area, South Lincolnshire

Post by toomanytoys »

You really need the codes off the boxes to see if the swap gives you much more..
Its probable the wbx box will be a little taller.. but the difference may not be enough.. get the codes..

Aidan is your man for a box to suit..

andysimpson
Registered user
Posts: 213
Joined: 19 Oct 2005, 21:15
80-90 Mem No: 0
Location: Chorley, Lancs

Post by andysimpson »

Laurie wrote:Not really. The petrol engine supplies power at far higher revs. Meaning the diesel runs at the same speeds at lower revs. I think you may be into a bespoke box if you want to match it properly.

Most petrol gearbox's would bring engine revs down slightly. A bespoke gearbox is not the anser becuase it won't have the low speed torque to make use of taller gears. All the idi 1.9's rev higher than waterleakers.

User avatar
Chopper
Registered user
Posts: 24
Joined: 15 Jun 2007, 13:55
80-90 Mem No: 5656
Location: West Cork, Ireland
Contact:

Post by Chopper »

Nice one guys. Thanks for that.
I think I'll stick with the original box for now and just get the thing back on the road.
I'm planning a TDi conversion in the future so I'll sort my gearbox issues then.

Locked