Just been replacing shocks on van & started prodding around rust at back of sill by trailing-arm - oh, dear!!
Now have a hole in outside pf panel & seam all way along sill, although underneath & mounting for arm seem solid enough. Presumably looking at inner sill & outer panel, wheel-arch & some filling in as well as flat bit to rear of wheel-arch.
Can anybody recommend a decent welder who does a good job & preferably not too far from Ilminster. How many hundreds of pounds am I looking at roughly (I know hard to estimate without seeing it!). Is it time to take that welding course after all??
Does anyone know if CJ at Syncro-spares does welding, as only 20-odd miles from him.
Many thanks to all - Happy Easter!!
Hope some of you are driving about in vans rather than lying underneath them - bought this a month ago & done about a total of 150 miles.
